IGM Diamond Cone Mortice Chisel Sharpener max.13 mm

145 kr Inkl. Moms

14 i lager (kan restnoteras)

Bara 14 stycken kvar i lager!

🚛 Gratis frakt över 1200kr

Garanterat säker kassa

IGM Diamond Cone Mortice Chisel Sharpener max.13 mm
145 kr Inkl. Moms
Aktivera JavaScript i din webbläsare för att slutföra detta formulär.
Namn

• Specially made diamond coated cone.
• For mortice chisels with a maximum size of 13 mm.
• Suitable for most Japanese mortice chisels.

Sharpened mortice chisel significantly improves performance of your tool and quality of the mortice.

We recommend this specially made diamond coated cone for most CMT and IGM Japanese mortice chisels and Veritas square hole punches.

Instructions:
1. Use the cone in a drill press or a mortiser if you have a chuck adaptor (a handheld drill is neither suitable nor safe).
2. Remove the drill bit from the chisel.
3. Clamp the slot mortising bit vertically and securely.
If need be, drill a hole of the same diameter as the chisel’s shank in a block of wood. Then insert the slot mortising bit into the hole.
4. While running at low speed (150 to 250 RPM) slowly lower the cone until it just makes contact with the chisel.
5. Carefully and gently grind the chisel until a clean surface around the entire bevel is obtained.
6. Use a fine sharpening stone or a fine diamond file to remove any burrs (not included).

Ytterligare information

Vikt 0,026 kg
Dimensioner 90 × 90 × 20 cm